![]() Use the multifunction wrench provided to tighten the nut securely onto the shaft (Fig. ![]() Insert the hex wrench provided into the aligned holes to act as a stabilizer (Fig.6). Rotate the spool base to align the slot in the flange with the hole in the gear case (Fig. Mount the nut onto the shaft, and pre-tighten it COUNTERCLOCKWISE by hand.Ħ. Position the plain washer onto the motor shaft (Fig. Align the mounting hole in the new spool base with the motor shaft, and then mount the new spool base onto the shaft.Ĥ. Position the flange cover onto the flange with its flat surface facing outwards (Fig. Position the flange removed in step 8 of the "Remove the trimmer head" section onto the motor shaft with the bulge facing away from the base (Fig. Check and replace them if they are worn.ġ. Remove the flange cover and then remove the flange from the motor shaft (Fig. Hold the spool base and pull it straight out from the motor shaft (Fig. Remove the plain washer from the motor shaft and save it for reassembly (Fig. Use the multifunction wrench provided to loosen the nut in the direction of the arrow marked on the spool base inside housing, and then remove it (Fig. ![]() Pull the spring out of the spool base (Fig. Press the 2 release tab on the spool retainer to remove it (Fig. Remove the battery from the Power Head.Ģ. 3 Wind the spool with new line Remove the trimmer headġ. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |